pio\build\esp32dev\firmware.elf Advanced Memory Usage is available via PlatformIO Home > Project Inspect RAM: 4.7 (used 15436 bytes from 327680 bytes) Flash: 16. Operating system: macOS Mojave 10.14.5 Python version: Python 2.7.15 ESP hardware in use: ESP8266 ESP-01 Full esptool.py command line as run: esptool.py -trace -p /dev/cu.wchusbserial1420 -baud 115200 writeflash 0x00000 v0.9.2.2\ AT\. Hello, here is my bord Geekcreit UNO + WiFi R3 ATmega328P+ESP8266 Module mmoire 32 Mo USB-TTL CH340G pour Arduino units When I try to upload a sketch, I get this error: esptool.py v2.8 Serial po. Supported android devices: Esp8266 Invalid Head Of Packet, Galaxy Note 3 Official, Yamaha Rx V675 Spotify, Sony Xperia X Performance F8131, Huawei Y520 U03 Mexico, Tcl 3t10 Wifi Kddi Aquaand many others. pio\build\esp32dev\firmware.elf Checking size.
English, Urdu, Basque, Konkani, Catalan, Serbian (Cyrillic, Serbia), Indonesian, Hindi, Bangla (India), Filipino, Tamil (India and Sri Lanka), Azerbaijani (Latin), Tatar, Maltese, Nepali, Central Kurdish (Arabic), Kinyarwanda, English, Punjabi (Arabic), Finnish, Marathi, Mongolian (Cyrillic), Scottish Gaelic, Chinese Traditional, Odia, Uzbek (Latin), isiZulu, Kyrgyz, Bangla (Bangladesh), Swedish, Tigrinya (Ethiopia), Polish, Serbian (Latin), Kannada, isiXhosa, Albanian, Valencian, KiSwahili, French, Arabic, Hungarian, German, Croatian, Galician, Irish, Japanese, Slovenian, Greek, Punjabi, Assamese, Bosnian (Latin), Thai, Lithuanian, Maori, Slovak, Persian, Macedonian, Sindhi (Arabic), Cherokee (Cherokee), Icelandic, Armenian, Malayalam, Kiche, Malay (Malaysia, Brunei, and Singapore), Welsh, Portuguese (Brazil), Dari, Norwegian (Nynorsk), Romanian, Norwegian (Bokmål), Italian, Czech, Telugu, Dutch, Igbo, Danish, Wolof, Afrikaans, Serbian (Cyrillic, Bosnia and Herzegovina), Georgian, Turkish, Tajik (Cyrillic), Gujarati, Ukrainian, Yoruba, Turkmen, Kazakh, Amharic, Khmer, Estonian Failed to connect ESP8266: Invalid head to Packet (0xf0) The selected port does not exist or the board is not connected I already installed the drivers and libraries, select the COM4 port and checked in the device manager that it is correct.